Assembly; Attach Handle - Bissell POWERTRAK 1307 Serie Guia Del Usuario

Assembly

You will need a Phillips screwdriver for assembly.

Attach handle

1. Locate the handle and the two screws
taped to the handle.
2. Slide the handle downward over the body
of the vacuum.
3. Insert two screws and fasten using screwdriver.
Attach hose and tools
1. Remove hose from package
2. Insert the hose with elbow end facing
downwards and align locking tab with slot.
3. Rotate clockwise until snapped into place
4. Take the opposite end and use the hose
end to open the foot base door, insert into
foot, and push into place.
5. Stretch hose and clip into the side and
upper hose clips.
6. Install extension wand and crevice tool in
the back of the unit as shown.
7. Remove TurboEraser Tool from packaging.
Install on front of vacuum by inserting end
upward into the handle. There will be a click
when fully installed.
8. The Long Reach Dusting tool does not
store on the vacuum (select models).
9. Take cord and wrap around the two cord
wraps located on the back of the vacuum.
WARNING
Plastic film can be dangerous. To avoid
danger of suffocation, keep away from
babies and children.
2.
2 & 3
5.
7.
3.
4.
6.
8.
www.BISSELL.com
5