Silhouette curio Manual De Instrucciones página 55

Loading Your Material
Preparing Your Mat
Choose your mat based on the type of project you want to make. If you are only cutting, use the
cutting mat. If your project needs to be embossed, use the embossing mat. You can cut on the
embossing mat as well, but it will last longer if you limit the number of cuts performed on the mat.
Remove the protective liner from the cutting mat or embossing mat.
Position your paper or other media on the mat according to the diagram shown in Silhouette Studio®.
Tip: To keep your material secure when embossing, place the material fasteners around the
edge of your material as needed.
If you don't see an image of the mat under your document on the screen, click the Page Setup
button in the options toolbar in the upper right-hand corner of the window.
Position your image on the screen where you want it to cut or emboss on the mat. Be sure to keep
your design within the red margins on your page.
7
Getting Started with Silhouette Curio™