Tabla de contenido
Publicidad
Once you have chosen the appropriate settings, click the Send to Silhouette button at the
bottom of the right panel.
The Curio will begin working. If needed, you can pause the job by pressing the 'Pause'
button on the side of the Curio. Press the button again to resume your job. To cancel
the job, hold down the pause button until the yellow light shuts off.
Once the Silhouette is done processing the job, press the "Load/Unload" button and
pull out the base to remove the material from the mat.
Replace the protective liner onto the cutting mat or embossing mat.
Additional Curio-related products are available
separately, including:
8.5"x12" base and mats.
These larger mats and base allow you to double your work area for larger projects.
etching tool
This tool is perfect for etching designs into metal sheets.
stippling tool
Stippling is the process of creating a design from a series of dots rather than lines. Use the
stippling tool to stipple designs into thin metal sheets or paper.
felt-tip pens
Felt tip pens enable you to draw with your Curio. You can also use the pens to stipple designs.
deep-cut blade
The Curio can accommodate thicker materials and the deep-cut blade is designed to cut
certain materials up to 2mm.
Getting Started with Silhouette Curio™
12
Publicidad
Tabla de contenido
