Parts - Truper SIMU-5A Manual De Instrucciones

• Before starting any cut the depth adjusting and bevel levers shall be tight and fastened. If the lever moves during the cut
they can bend the disc and cause kickback. An excessive cutting depth position increases the load in the unit and the
possibility that the disc is bent inside the cut. It also increases the possibility the cut closes increasing the available area
above the cutting disc.
Toxic materials
Dust originated by some materials have chemical
substances known to cause cancer, birth defects and
other reproductive damage. Some of these chemical
substances are:
• Lead in lead-based paints.
• Crystal silica in bricks and cement and other masonry
products.
• Arsenic and chromium in wood treated with chemical
substances.
• Asbestos.
Lubricant
wax orifice
Lubrican wax dosage
measure knob
Discs aligning
orifices
Cutting discs
6
ENGLISH
Retractable guard
control lever
Fixed
guard
Auxiliary
handle
the handle rotation
Auxiliary
Switch
handle
Safety warnings for
manual saws
The risk involved to exposure to these substances varies
according to the frequency of the job. To reduce
exposure to these chemical substances work in
well-ventilated areas and wear the right safety equipment
like anti-dust mask specifically designed to filter
microscopic particles.

Parts

Button to block
the handle rotation
Button to block
Switch
Key
Rotating
handle
Retractable guard
control lever
Fixed
guard
Retractable
guard
Switch lock
Pin
Lubrication
device
Block
screw
Power cord