Truper SIMU-5A Manual De Instrucciones página 23

Parts
Rotating handle
The tool handle can rotate to allow a more confortable
operation depending on the job. Press the button (A) to
block the handle rotation and turn until it clicks into the
desired position.
Retractable guard
Before each use double-check the retractable guard (B)
and its spring (C) work correctly. If the guard is not
moving freely or is not closing instantly, service before
operating the tool.
The retractable guard can work slowly because of damaged
parts, gummy deposits or debris accumulation. To avoid this
possibility clean regularly the inside of both guards and the
disc axis with kerosene or compressed air. Before carrying
out this cleaning operation disconnect the tool and remove
the cutting discs.
The retractable guard can only open manually to change
discs and to mark cuts or to combine cuts. Using its lever
(D) open the retractable guard. When the material enters
into the material, release the lever. To make any other
type of cuts the retractable guard shall operate
automatically. Never fix the retractable guard in its open
position.
C
D
The retractable guard may get bent due to knocking or
falling. Before operating the tool, double-check the disc
moves freely in all the angles and cutting depths and the
guard is not touching the cutting disc or any other part of
the tool.
WARNING
the floor double-check the retractable guard covers de
disc. A rotating disc due to inertia can cause the saw to
run backwards and cut whatever it finds on its way.
Verify the disc stops moving after turning off the tool.
WARNING
rotating disc underneath the work piece. Never squat or put
the hand under the work piece when the tool is running.
C
B B
A
Before setting the saw on the bench or
Remember the guards do not protect the
ENGLISH
D
7