Maintenance - Truper SIMU-5A Manual De Instrucciones

Start up
Corrugated steel sheet
To cut corrugated steel sheet up to 1/6" thick, ALWAYS
fasten the sheet with support blocks on both sides, evenly
and in the middle. This prevents the sheet to bend when
cutting. Follow this indication even if using a vise or
brackets adjusted to the worktable.
Penetrating cut
• Open the retractable guard completely.
• With your left hand grasp the auxiliary handle and with
your thumb hold the retractable guard control lever to
keep it open.
• Start the tool and penetrate the discs into the material.
Once inside the material push the discs forward to
complete the cut.
• Before removing the discs from the work piece shut off
the tool and wait for the disc to come to a complete stop.
NOTE: When cutting roofing materials, clean the discs
with a solvent to clean tar.

Maintenance

Remember to disconnect the tool before cleaning or
servicing.
All the tool components are an important part of the
insulation system and can only be serviced in a
Authorized Service Center.
When sending the tool to be serviced, ALWAYS ask for
original
When cleaning plastic parts avoid using solvents. Most of
plastic materials are susceptible to damage with several
types of commercial solvents.
To clean soot, coal or dust, use a clean cloth or
pressurized air.
A WARNING DVERT NEVER set the tool in contact with
brake fluid, petroleum based products, penetrating oils,
etc. They are made with chemical substances that can
damage or destroy plastic.
spare parts.
WARNING When using pressurized air to clean
particles ALWAYS wear safety glasses with side protection
or a facemask. If too much dust is expelled wear an
anti-dust mask.
It is not advisable to use this tool for extensive jobs in
fiberglass materials, gypsum wallboard, plaster or
gypsum. The particles shed are highly abrasive for the
components of any power tool. In the event of using t he
tool on one of these materials it is important to frequently
clean the tool with pressurized air to increase the useful
life of the tool.
Lubricating
The tool bearings have high-grade lubricant to keep it
lubricated for life when used under normal conditions. It
does not require lubricating.
11
ENGLISH