Guard Plate Installation; Nylon Line Head Installation - Shindaiwa BP35 Manual Del Proprietario / Usario

Guard plate installation

(For nylon line operation)
The cut off knife on the debris shield has sharp edges.
Avoid contact when installing or removing the line head.
NOTE
Make sure the guard plate is completely hooked at the hook receiver.
Attach the guard plate to the shield.

Nylon line head installation

(Use with guard plate)
Fasten output shaft using locking tool securely in order to avoid the possibility of
output shaft rotating when mounting nylon line head.
1. Blade retainer. 2. Locking tool (4 mm hexagonal wrench).
4. Loosing direction. 5. Bolt.
Align locking hole in blade retainer with notch at the edge of angle transmission and insert
locking tool.
The bolt has a left hand thread and can be removed by turning clockwise.
Remove the bolt guard.
7. Nylon line head
Mount line head to output shaft by turning it anticlockwise until head is tight against blade
retainer.
Remove locking tool.
WARNING
CAUTION
6. Bolt guard.
18
3. Socket wrench.