Stopping The Engine; Left Hand Operation - Shindaiwa BP35 Manual Del Proprietario / Usario

Stopping the engine

If engine does not stop, close choke to stall engine.
Have your shindaiwa dealer inspect and repair ignition switch before using the unit.
1. Throttle trigger. 2. Ignition switch.
Release throttle trigger and allow engine to idle.
Push ignition switch down.
3. Spark plug cap. 4. Spark plug.
Always disconnect the spark plug cap (ignition cable) from the spark plug to ensure the engine
cannot be started before you work on the unit or leave it unattended.

Left hand operation

1. Exhaust guide. 2. Clamp screw (M4 X 10).
4. Left hand operation.
Some users of the unit may wish to operate the unit left handed.
It is very important to follow these instructions if you wish to do so.
- Loosen the exhaust guide clamp screw (M4 X 10) and rotate the exhaust guide
approximately 90 degrees clockwise as viewed from the top of the engine.
- Tighten the clamp screw (M4 X 10) firmly to prevent the exhaust guide from moving out
of position.
- Put unit on, and in the operating position, check exhaust guide to make sure exhaust flow
is out and to the side of the operator.
Readjust if necessary.
WARNING
21
3. Right hand operation.