Assembly - Movement idea Manual Do Proprietário

5

ASSEMBLY

CAREFUL!
Before starting to assemble the equipment, care must be taken in the following cases:
•Make sure that the packaging is undamaged and that parts and components of the equipment are not damaged.
•It is recommended that the equipment be unpacked at the place where it will be assembled.
•The assembly unit must be cleaned.
•The ground should be flat and level, firm / rigid to prevent treadmill instability.
•The space around the equipment must be free as described in this Manual (see Operational Instruction Chapter).
•It is recommended that the equipment be assembled away from moisture and away from sunlight in order to avoid damaging
the electronic parts of the equipment.
•The icons have a function to instruct the user in which the tool is to be used, how many people should make the assembling,
or cross-tighten the screws without determining the pitch.
TABLE OF SPECIFICATION OF SCREW
TIGHTENING TORQUE
Diameter [mm]
M10
Fixed Wrench Allen
5,5 mm n°3
10 mm n°5
13 mm n°4
17 mm n°6
n°8
SPACE
We recommend that for the safety of the users the equipment be used in an area
that is not frequently used based on the figure to the side. The access and escape
area can be common among the equipments used. The space is valid for all
equipment.
Torque [N.m]
M6 9-12
M8 22-29
45-58
TOOLS
Screw threader
Wrench
medium torque
Philips
242
Assembly by two
people is
recommended.
Pliers for
elastic ring
10
ICONS
50% 100%
Don't fully tighten
the bolts.
60 cm
Fully tighten
the screws.
60 cm