Cleaning And Maintaining The Device - HEINE EN200 BP Manual Del Usuario

•
The device may not be used together with HF surgery, x-rays and MRI.
•
The device must not be operated near devices that emit powerful electrical
radiation, such as radios, mobile telephones or microwave units.
•
Do not repair the device yourself if faults occur.
•
Only allow the manufacturer or authorised service centres to perform
repairs. The device must be subjected to a further metrological control
after a repair.
•
Protect the device against moisture. Avoid further use if moisture should
penetrate into the device. In this case, contact your dealer or inform us
directly. In this case, the device must undergo a safety check (STK).
•
If the device is exposed to adverse environmental conditions (e.g. high
humidity in bathrooms), the likelihood of malfunctions must be clarified
in each specific case. Please contact the manufacturer.
•
Any modifications to the device are prohibited.
•
The use of accessories, removable parts and materials that are not
described in these instructions for use is prohibited. Only use original
HEINE accessories.
•
Over-stressing due to dust, fluff and exposure to light may damage the
device. Please pay attention to the storage conditions.
•
Should you forget to switch off the device, the device will automatically
switch off after 2 min.
5.3

CLEANING AND MAINTAINING THE DEVICE

•
Never use aggressive detergent or sturdy brushes.
•
Clean the device using a soft cloth, which you moisten using
a mild soap solution.
•
Ensure that no water penetrates into the device. Only use the device
once it is completely dry.
•
Never expose the device to direct sunlight; protect it against dirt
and moisture.
•
Only inflate the cuff once it has been positioned on the upper arm.
MED 113275 2017-05-02
61/176