Black and Decker LST201 Manual Del Usuario página 10

• Remove any remaining cutting line from
the spool.
• Make a fold at the end of the cutting line
at about 3/4 inch (19mm)(20). Feed the
cutting line into one of the line anchoring
slots (21) as shown in figure O.
O
• Insert the 3/4 inch (19mm) end of the
bulk line into the hole (22) in the spool
adjacent to the slot as shown in figure P.
Make sure the line is pulled tight against
the spool as shown in figure P.
P
23
• Wind the cutting line onto the spool in
the direction of the arrow on the spool.
Make sure to wind the line on neatly and
in layers. Do not crisscross (figure Q).
• When the wound cutting line reaches the
recesses (23), cut the line. (figure P).
• Fit the spool onto the
appliance as described in
"REPLACING THE SPOOL".
Q
MAINTENANCE
WARNING:
remove the battery from the appliance
before performing any maintenance.
1. Keep the air intake slots clean to avoid
overheating.
20
21
22
To avoid serious injury,
2. Your trimmer line can dry out over time. To
keep your line in top condition, store spare
pre-wound spools or bulk line in a plastic,
sealable bag with a tablespoon of water.
3. Plastic parts may be cleaned by using a
mild soap and a damp rag.
4. The line cutter on the edge of the guard
can dull over time. It is recommended
you periodically touch-up the sharpness
of the blade with a file.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment should be performed
by authorized service centers or other
qualified service organizations, always
using identical replacement parts.
This Class B digital apparatus complies
with Canadian ICES-003.
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
This Class B digital apparatus complies
with Canadian ICES-003.
10