Ingersoll Rand HD Serie Manual Del Usuario página 5

The following equipment is available at an extra price and must be ordered separately:
1. Bearing Inserting Tool (for HX or HXD models)
2. Cone Wheel Adapter (for HX models)
3. Router Attachment Assembly
for models using 1/4" diameter bits
for models using 3/8" diameter bits
4. Trimmer Guide (for Router Attachments)
for 1/4" shank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
for 1/4" shank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
for 3/8" shank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
All the models listed on Page 5 can be changed to front exhaust tools by reversing the Flow Ring and aligning the the
indicator marks with the letter "F" on the Housing. To order a front exhaust tool from the factory, substitute the letter "F"
for the letter "R" in the above models. Example: HD180RG4 Rear Exhaust Model becomes HD180FG4 Front Exhaust
Model.
1. To order a tool with a Locking Lever, select the
desired model and add an "L" to the end of the
existing number.
Example: HD180RG4L
Anytime a tool is ordered with a Low–Profile
Concentric Flange, it will come equipped with a
Locking Lever from the factory.
NEW GRINDER TO ACCESSORY COLOR MATCHING GUIDE
Ingersoll–Rand has pioneered a new color code system
designed to:
1. Simplify the identification of rated tool speed via a
unique corresponding color match.
2. Easily communicate the appropriate backing pads and
PLACING TOOL IN SERVICE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
HOW TO ORDER CUSTOM MODELS
(READ FROM LEFT TO RIGHT)
5
2. To order a tool with a Low–Profile Concentric Flange,
select the desired model and add a "C" to the end of
the existing number.
Example: HD180RG4C
accessories for each tool through a matching color
code system on the backing pads and/or other
corresponding Grinder accessories.
3. The chart below demonstrates the color code system
between the Grinder and the accessory.
Part No. LE2–950
Part No. LE2–104–L6
Part No. TD–RK4
Part No. TD–RK6
Part No. R120–128–2
Part No. R120–128–7
Part No. LG2–129–1
(Dwg. TPD1146–1)