How To Install The Pad; Dust Bag Installation; Adjusting Pad Pressure - Clarke FUSION 20 Libro De Instrucciones

HOW TO PREPARE THE MACHINE FOR OPERATION

How To Install The Pad

To install or remove pad on the machine, follow this
procedure (see steps 1 - 6 in Figure 6):
1. Turn the key switch off "O".
2. Put the machine in the position shown (2) to
accss the pad retainer.
3. Go to the front of the machine. While holding the
pad retainer with one hand, rotate the pad and
pad driver counter clockwise to loosen the pad
retainer.
4. Remove the old pad and install a new one, being
careful to center it on the outside diameter of the
pad driver. NOTE: Vibration could occur if you
center the hole in the pad to the opening for
the pad retainer. Always use a high quality
pad rated to operate at 2000 rpm.
5. Retighten the pad retainer as tight as possible.
6. Raise the back of the machine to lower the pad
housing by lifting as shown (6).
Dust Bag Installation (see figure 7)
Install dust collector bag (part number 54195A) on top of
control housing. The dust collection system will not
operate properly if the collector bag is full or torn.

Adjusting Pad Pressure

The pad pressure is set at the factory for optimal
burnishing with most pad and finish combinations. If
unique pad or finish conditions require pad pressure
adjustments, adjust by following the procedure below.
NOTE: Pad pressure adjustments should be performed
by a qualified service technician. (see figure 8):
1. Turn the key switch off "O".
2. From underneath burnisher, loosen jam nut (A).
3. To decrease pad pressure, turn bolt (B) clock-
wise.
4. To increase pad pressure, turn bolt (B) counter-
clockwise.
5. Re-tighten jam nut (A).
Clarke ®
Operator's Manual (EN) - FUSION 20 / 20T
ENGLISH
Figure 7
A
Figure 8
EN
B
- 9 -