Description Of The Kit; Safety Notices; Degree Of Protection; Optional Module Description - WEG SSW-07 Guia De Instalacion

1. DESCRIPTION OF THE KIT

Contents:
SSW-07 Remote Keypad kit (Part number: 417114751)
Quantity
1
1

2. SAFETY NOTICES

ATTENTION!
Switch off the Soft-Starter SSW-07 before installing the Remote Keypad kit.
The electronic boards have components that are susceptible to electrostatic
discharge. Never touch any of the electrical components or connectors
without following the proper grounding procedures. If it is necessary to do so,
touch the grounded heatsink or use a suitable grounded wrist strap.

3. DEGREE OF PROTECTION

IP54 - NEMA 12 (mounted in the door of the panel) shown in figure 2.

4. OPTIONAL MODULE DESCRIPTION

The Remote Keypad is mounted externally to the Soft-Starter, with a cable length
up to 10m, on the panel door or command console.
The Remote Keypad Interface is used exclusively for the connection of the Remote
Keypad to the Soft-Starter. It is fitted into the front cover slot for optional plug-in
modules.
The cable used to connect the Remote Keypad to the Soft-Starter is an option and
is available in sizes of 1m (3.3ft), 2m (6.6ft), 3m (9.8ft), 5m (16.4ft), 7.5m (25ft) and
10m (33ft).
NOTE!
The Remote Keypad does only work together with the Remote Keypad
Interface and the appropriated cable.
NOTE!
The Keypad parameter programming must be done according to the SSW-07
programming manual that is available on the CD that comes with the
Soft-Starter or at WEG's web site (www.weg.net).
The Remote Keypad dimensions are shown in the figures 1 and 2.
Table 1 - Contents of the Kit
Description
Remote Keypad connection optional module
Remote Keypad
5