Tractel blocfor 20R ESD Manual De Instalación, De Utilización Y De Mantenimiento página 4

blocfor™ are CE self-closing fall arresters that
are covered by the PPE Directive. The certificate
of conformity issued by APAVE covers its use in
accordance with the requirements of EN 360:2002
GB
standards.
The PPE certificate of conformity issued by APAVE
excludes applications associated with other uses such
as compliance with
Rescue System.
1. Priority instructions specific to
recovery equipment
1. Before using the blocfor™ and to ensure safe, efficient
use of this equipment, it is essential that the operator
be properly trained in the use of this equipment and
has read and understood the information given in the
manual supplied by TRACTEL SAS. This manual
should be available at all times to all operators.
Additional copies can be supplied on request.
2. Before use, it is essential that operators are trained
in the use of this safety device. Check the state
of associated equipment and make sure that the
clearance is sufficient.
3. The blocfor™ fall arrest device must only be used by
trained and skilled personal, or under the supervision
of trained and skilled personal.
4. If a blocfor™ fall arrest device is not in good condition
or has been used to stop a fall, all equipment must be
checked by TRACTEL SAS or by an authorised and
competent technician who must authorise in writing
the reuse of the system. A visual inspection before
each use is recommended.
5. Any modification or addition made to the equipment
cannot be done without prior written approval from
TRACTEL SAS. The equipment must be transported
and stored in its original packaging.
6. Any blocfor™ fall arrest device that has not been
periodically examined in the last twelve months or
has stopped a fall must not be used. It may only
be used again after a new periodic examination
by an authorised and competent technician who
will authorise its use in writing. If these tests and
authorisations are not carried out, the blocfor™ fall
arrest system must be destroyed.
7. The maximum working load is 150 kg for the
blocfor™ fall arrest device.
8. In order to provide protection for the operator up to
the maximum 150kg weight (operator + equipment +
tools), each component of the fall arrest system must
4
norm EN1496:2017, Elevation
be certified to 150 kg standard. The weakest element
in the chain always determines the maximum working
load for the entire system.
9. This equipment is suitable for use on site in the open
air and for a temperature range between -35°C and
+60°C. Avoid contact with sharp edges, abrasive
surfaces, chemicals.
10. If you are responsible for assigning this equipment
to an employee or similar person, ensure that you
comply with the applicable health and safety at work
regulations.
11. The operator must be physically and mentally
fit when using this equipment. In case of doubt,
consult your doctor or the occupational physician.
The use of the equipment by pregnant women is
prohibited.
12. This equipment should not be used beyond its limits
or in any other situation other than what it has been
designed for: see "4. Functions and description".
13. It is recommended that this blocfor™ fall arrest
device is personally allocated to each operator,
especially if this is an employee.
14. Before using an EN 363 fall-arrester device, the
user must ensure that each of the components is
in good working condition: security system, locking
system. During implementation, there must be no
degradation of security functions.
15. In a fall arrest system, it is essential to check the
clear space under the operator at the workplace
before each use, so that in the event of a fall there
is no risk of collision with the ground or presence of
an obstacle on the path of the fall.
16. A fall arrest harness is the only body gripping device
that is permitted to be used in a fall arrest system.
17. It is essential for the safety of the operator that the
device or anchoring point is correctly positioned and
that work is carried out so as to minimise the risk of
falls from height.
18. For the safety of the operator, if this equipment
is sold outside the first country of destination,
the distributor should supply: an instruction
manual, instructions for maintenance, for periodic
inspections and repairs, all compiled in the
language of the country of use.
19. The maximum working load is 150 kg for the
automatic fall arrest system blocfor™ 20R/30R
whether in fall arrest (EN 360) or rescue by
elevation (EN 1496 class B).
20. There must be a specific rescue plan specific
rescue plan has been put in place if there is a fall.