Setup - Textron JACOBSEN G-Plex III DN Serie Manual De Seguridad Y Operacion

8

SETUP

GB
8.1 SET UP
IMPORTANT!
CALIFORNIA PUBLIC RESOURCES CODE,
SECTIONS 4428-4442, REQUIRE SPARK
ARRESTERS WHEN OPERATING ANY INTERNAL
COMBUSTION ENGINE USING HYDROCARBON
FUELS, ON FOREST-, BRUSH-, OR GRASS-
COVERED LANDS.
WARNING
Setup procedures must be performed as
specified by properly trained service
personnel only.
Check the hydraulic system. Make sure the
connections are tight and all hoses and lines
are in good condition before pressurizing the
system. Hydraulic spstem should be allowed to
warm-up and re-check connections for leaks.
WARNING
If a leak is suspected, use a piece of
cardboard or wood, NOT your, to check
for leaks.
Hydraulic Fluid escaping under pressure
can penetrate skin and do serious
damage. Immediate medical assistance
must be sought.
Serious infection or reaction can develop
if proper medical treatment is not
administered immediately.
NOTE: Any reference to the right, left, front,
or rear of the unit will always be
determined from the operators seated
position.
GB-18
JACOBSEN G-PLEX III Series: DN & DP
SAFETY AND OPERATORS MANUAL