Prepare The Hood - NuTone ALLURE WS15 Serie Manual De Uso

PREPARE HOOD LOCATION
ROOF CAP
SOFFIT
CABINET
HOOD HOOD
24" - 30" ABOVE
COOKING SURFACE
1 Determine whether hood will discharge vertically (3¼" x 10"
or 7" Round), horizontally (3¼" x 10" only) or non-ducted. For
vertical or horizontal discharge, run ductwork between the
hood location and a roof cap or wall cap. For best results, use
a minimum number of transitons and elbows.
2 Use diagrams, below, for proper placement of ductwork and
electrical cutout in cabinet or wall. For a non-ducted installa-
tion, DO NOT cut a duct access hole.
HOOD MOUNTING SCREWS (4)
15 /
13 "
16
CABINET FRONT
CABINET BOTTOM
5¼"
VERTICAL DUCT
5" ACCESS HOLE
1¼"
WOOD SHIMS
CENTER
(recessed-bottom
cabinets only)
WOOD SHIMS
(recessed-bottom
cabinets only)
CABINET FRONT
3¾" HORIZONTAL DUCT
CABINET
5¼"
BOTTOM
13 "
15 / 16
HOOD
MOUNTING
SCREWS (4)
3¼" X 10"
3¼" x 10" or
(For vertical 7" ROUND DUCT
(For vertical discharge)
discharge)
HOUSE WIRING
(Top or Back of hood)
WALL CAP
3¼" X 10" DUCT
(For horizontal discharge)
3¼" X 10"
VERTICAL DUCTING
15 /
13 "
16
7½"
5¼"
2"
ELECTRICAL
ACCESS HOLE
(in cabinet bottom)
LINE
3¼" X 10"
HORIZONTAL DUCTING
" ¾"
1 / 8
ACCESS HOLE
5¼"
7½"
13 "
15 / 16
ELECTRICAL
CENTER
ACCESS HOLE
LINE
(in wall)
PREPARE HOOD LOCATION
3 Run house wiring between service panel and hood location.

PREPARE THE HOOD

10½"
1½"
Remove 7" Round Duct Plate from top of hood. Set duct
1
plate aside - with mounting screws.
2 Remove tape holding Filters in place. Pull down on filter
handle/latch and lift filters out. Set filters aside.
ALLURE™ WS15 SERIES
13 " 13
15 / 16 15 / 16
7" ROUND
DUCT PLATE
RANGE HOOD
Page 2
7" ROUND
VERTICAL DUCTING
"
FILTERS