Tabla de contenido
Publicidad
Tools/Outils/Herramientas
Propane Torch
Chalumeau à propane
Soplete de propano
Drill and Hole Bit
Perceuse et mèche cylindrique
Taladro y broca de corona
Important Information
WARNING: Risk of personal injury. This product is a diverter valve only and
should never be used as a shut-off valve. Doing so would allow cross flow
between the hot and cold water supplies and create a serious scalding hazard.
Observe all local plumbing and building codes.
Shut off the main water supply.
Provide an access panel for all installations.
Carefully read this entire instruction manual before beginning the installation; the
illustrations do not show all possible configurations.
This diverter can be installed to decks with a maximum thickness of 1-1/4" (3.2
cm).
Carefully inspect waste and supply tubing for any sign of damage. Replace if
needed.
You can extend the distance between the water source and the braided hose
connection with 1/2" copper piping below the rim of the bath/whirlpool, but it
may not be safe or practical. A long run of piping will mean a long run of
room-temperature standing water when the handshower is first activated for use.
This diverter can be used in either a deck-mount or wall-mount installation. Refer
to the "Diverter Configurations" section for any special considerations.
Do not install spouts with flow restrictors or handheld shower units on the large
(5/8" OD) bath outlet.
The Kohler two-way diverter is designed for use with Kohler non-diverting bath
spouts.
Remove all internal components of the diverter valve before soldering. Kohler
Co. recommends soldering supply and optional outlet connections to avoid
potential leakage.
1138924-2-B
Plus/Plus/Más:
• Supply piping, connectors,
and caps
Tuyauterie d'alimentation,
connecteurs et capuchons
Tubos de suministro,
conectores y tapones
Solder
Soudure
Suelda
3/32"
Hex Wrench
Clé hexagonale
Llave hexagonal
2
Kohler Co.
Publicidad
Tabla de contenido
