Electronic Control; Programming Time Functions; Setting The Time Of Day - Fulgor Milano FQO 6010 P MT Instrucciones Para La Instalación Y Uso

GB

ELECTRONIC CONTROL

Control panel description ("EXTRA SMALL")
The oven control panel is made with one display and two knobs.
- Time & Temperature display.
- Time & Temperature knob (Push & Shuttle).
- Mode (oven functions) knob.
TEMP & TIME MODE
The push & shuttle knob is mainly for clock or temperature setting and automatic time
functions programming. Select the desired item by pushing the knob.
Power-up
At every power-up, in pyrolytic ovens, the latch mechanism runs an automatic self-test:
the oven door locks and unlocks. This operation takes about half a minute. The lock led
turns on and flash while the action is in progress, it remains steadily displayed when the
door is fully locked, it's off when the door has been unlocked.
Do not try to open the door until the lock led disappears.

Programming time functions

At every power-up, the control shows the time of day blinking, set at 12:00 as the
initial value. The time increases every minute. The only possible action is the "Clock
Regulation", all other oven operations are inhibited.
In general, turn the Temp/Time selector left or right in order to edit the values and
modify them by steps; hold the knob on the left or right to fasten the decrease/increase
operations.

Setting the time of day

The time of day is always displayed in the 24 hours format. Hours and minutes are set
separately. In order to set the time of day, mode selector must be in ZERO position, the
-/+ knob acts on the time of day by default.
12