Metra 99-5027 Instrucciones De Instalación página 12

ISO DIN radio provision with pocket
1. Attach the ISO brackets to the radio housing, and
then secure using the (2) #8 x 3/8" Phillips screws
provided. (Figure A)
2. Remove the metal DIN sleeve and trim ring from
the aftermarket radio.
3. Slide the radio into the rear of the radio opening
and then secure with the screws supplied with the
radio. (Figure B)
4. Snap the trim plate into the radio housing. (Figure B)
5. Locate the factory wiring harness and antenna
connector in the dash. Metra recommends using the
proper mating adapter from Metra or AXXESS. Test
the radio for proper operation.
6. Reassemble the dash in reverse order of
disassembly.
99-5027
Kit Assembly
(Figure A)
12
(Figure B)