General Warning - Iberital IB7 Manual De Instalación Y Funcionamiento

IBERITAL
When we begin to fi ll the deposit manually and the water covers the minimum level sensor, the LEDs will turn off and the
control unit will once more allow the electrical current to reach the element and pump.
Maximum Level – When we are fi lling the tank manually with water and reach the maximum level, the
LED on the non-stop button lights up, indicating that we must stop adding water to the deposit. This LED
will remain lit until the water level is below the maximum level sensor.

GENERAL WARNING

If your machine has a visual display, the respective alarm will be shown on the screen based on the
incident (see the section on visual display operation).
2.3.4. Programming hot water (only available on Iberital Expression Pro model and
optional in New Iberital)
Enter programming mode, pressing the "non-stop" button for 5 seconds on the button pad for any group; the "nonstop"
LED will light up.
- If the option 'NO' MIXED TEA is selected on the visual display or for machines without visual display:
• Press the hot water button. At that moment hot water will begin to come from the boiler.
• When the desired dose has been obtained, press the hot water button again.
• The hot water setting has been programmed.
- If the option MIXED TEA is selected on the visual display or for machines without visual display:
• Press the hot water button. At that moment mixed water (hot/cold) will begin to come from the boiler.
• Press the hot water button. At that moment hot water will begin to come from the boiler.
• When the desired dose has been obtained (fi rst press + second press), press the hot water button again.
• The fi nal hot water setting has been programmed.
NOTE (versions with visual display and miscellaneous solenoid valve)
At the same time there is a manual regulator found on the side of the water mixing solenoid valve.
2.3.5. Automatic steam programming (optional, only available on some models)
When our model has automatic steam (which will always be located on the left), on going through the technical menu
we will see the option to change various temperatures:
• LCD display screen (non-touchscreen): on going through the technical menu, we will see the option to
change two temperatures:
- Temperature 1: This is the fi nal temperature of the milk, whether hot milk or frothy milk.
- Temperature 2: This is the temperature from which air begins to be injected together with the steam,
in order to improve the froth of the milk.
NOTE
Iberital recommends setting the following temperatures:
• Temperature 1 not above 80ºC (176ºF).
• Temperature 2 between 30°C (86°F) and 40ºC (104ºF).
80 INSTALLATION AND OPERATION MANUAL