Introduction; General; Scope Of The Manual - Masterflex Digi-Staltic L/S 77310-00 Manual De Operación

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

GENERAL

®
The MASTERFLEX
L/S
up to four pump drives. Each pump drive can operate two EASY-LOAD
and approximate physical size for the Dispensing Systems and component parts. Each pump drive is identified by the
control console with a unique number from 1 to 4, depending to which port on the console the pump drive is connected.
Pump drives are available for use with precision tubing or high-performance precision tubing.
Component for Use with...
L/S DIGI-STALTIC Pump System
Control Console (included with
system)
Pump Drive (included with system)
Pump Drive with no pump heads
EASY-LOAD II Pump Head
* Includes two 77200-60 EASY-LOAD II Pump Heads
† Includes two 77200-62 EASY-LOAD II Pump Heads
Units are protected against vertically falling water and incidental splashes.
The L/S DIGI-STALTIC Dispensing System is a microprocessor-controlled, programmable peristaltic pump system
designed to meet liquid-handling needs. The system can be programmed to operate as a dispenser, diluter/dispenser,
and an all-purpose pump. The operator designs programs that contain operational parameters. The programs can be
run manually with the controller, a dispensing wand, or by using the optional footswitch, semiautomatically in cycle, or
automatically by specifying the exact number of cycles to be completed.
The control console can control each pump independently, or pumps can be linked and controlled simultaneously.
Operation can be varied to suit specific applications by dispensing cumulative volume, flow in mL/min, and/or by cycle
count. The dispenser can communicate with a variety of balances in order to dispense liquid by weight. A built-in RS-232
interface allows the dispenser to be controlled by a personal computer.

SCOPE OF THE MANUAL

This manual contains instructions for installing, setting up, programming, operating, and maintaining the dispensing
system. It is intended for use by technicians and operators as well as maintenance personnel. TROUBLESHOOTING
contains a list of possible problems, their probable causes, and actions to take to remedy each problem.
®
®
DIGI-STALTIC
Dispensing System, as shown in Figure 1, consists of a control console and
Table 1. L/S DIGI-STALTIC Pump Drives
Precision
Tubing
77340-00*
77310-02
77340-50*
77310-01
77200-60
Figure 1. L/S DIGI-STALTIC Modular Dispensing System

INTRODUCTION

®
II Pump Heads. Table 1 lists catalog numbers
High-Performance
Precision Tubing
77310-00†
77310-02
77310-50†
77310-01
77200-62
1
Size (W × D × H)
Approximate Weight
in inches (cm)
8.9 × 6.5 × 2.7
(22.6 × 16.5 × 6.9)
9 × 12.6 × 7.4
(22.8 × 32 × 18.8)
in lbs. (kg)
3 (1.4)
20 (9)

Publicidad

Tabla de contenido
loading

Tabla de contenido