Tuner; Listening To The Radio - Pioneer Super Tuner III DEH-P6450 Instrucciones Y Manual De Operación

Tuner

02

Listening to the radio

These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on page 12.
Important
If you are using this unit in North, Central or
South America, reset the AM tuning step (see
Setting the AM tuning step on page 31).
1
( ) indicator
STEREO ST
Shows that the frequency selected is being
broadcast in stereo.
2
indicator
BAND
Shows which band the radio is tuned to, AM
or FM.
3
PRESET NUMBER
Shows what preset has been selected.
4
indicator
FREQUENCY
Shows to which frequency the tuner is
tuned.
1 Press
SOURCE
Press until you see
SOURCE
2 Use to adjust the sound level.
VOLUME
Rotate to increase or decrease the volume.
3 Press
BAND/ESC
Press
BAND/ESC
played, , ,
FM1 FM2
1 2 3
4
indicator
to select the tuner
.
displayed.
Tuner
to select a band
.
until the desired band is dis-
for FM or .
FM3 AM
4 To perform manual tuning, press 2 or 3
with quick presses.
The frequencies move up or down step by step.
5 To perform seek tuning, press and hold 2
or 3 for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
• You can cancel seek tuning by pressing either
2 or 3 with a quick press.
• If you press and hold 2 or 3 you can skip
broadcasting stations. Seek tuning starts as
soon as you release the buttons.
Note
• When the frequency selected is being broad-
cast in stereo the
STEREO (
light.
Section
03
ST indicator will
)
11
En