Selecting The Brightness; Switching The Rear Output Setting; Switching The Telephone Muting/Attenuation - Pioneer Super Tuner III DEH-P6450 Instrucciones Y Manual De Operación

Section
Initial Settings
07

Selecting the brightness

You can select the display brightness. Initially
this mode is set to 12.
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
2 Select the desired brightness with 2/3.
• The display shows

Switching the rear output setting

This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer out-
put on (refer to Using subwoofer output on
page 28).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
2 Select full-range speaker or subwoofer
with 2/3.
Pressing 2/3 will switch between
(full-range speaker) and
and that status will be displayed.
32
En
to select .
BRIGHT
repeatedly until
Brightness
– .
0 15
to select .
SW
repeatedly until
FRT+REAR
FRT+REAR
(subwoofer)
FRT+SW
Switching the Telephone
Muting/Attenuation
Sound from this system is muted or attenuated
automatically when a call is made or received
using a cellular telephone connected to this
product.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
2 Switch the telephone muting/attenuation
with 2/3.
Pressing 2/3 will switch between
(attenuation) and
:ATT
ing) and that status will be displayed.
.
TEL
Telephone
Telephone
(mut-
Telephone :MUTE
07