Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Table of Contents
2
General Architecture
The ENGAGE Gateway can work in two modes.
2
1. RSI Mode
2
In this mode, the Gateway communicates with
an access control panel (ACP) and alliance
partner access control software to control
the system. Power is supplied by the ACP
3
power connector (12 or 24V) or the wall power
4
supply. Data is supplied by either 2 or 4 wire
RS-485 connection from the ACP.
2. IP Mode
In this mode, the Gateway communicates with
an IP-based host. Power is supplied by either
POE on the Ethernet cable or the wall power
supply that is included with the Gateway. Data
5
is supplied over Ethernet.
6
7
Power Status
Power status is indicated by the status LED
located on the top face of the ENGAGE Gateway.
Communication Status
9
When the Gateway is configured to communicate
10
with an RS-485 access control panel, the transmit
12
and receive status is indicated with two LEDs,
located on either side of the RS-485 connector.
12
When the Gateway is configured to communicate
13
with an IP-based host over Ethernet, the status of
the LAN link is indicated on the Ethernet port of the
14
Gateway.
15
15
Customer Service
1-877-671-7011
Features
www.allegion.com/us
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
