Access Control Panel Connections - Schlage GWE Manual De Instrucciones

Gateway
Gateway
Connector
+
Power
–
Rx –
Tx –
RS485 Rx +
Tx +
GND

Access Control Panel Connections

Access control
panel signal
12 or 24 VDC
DC Ground
– Receive Data
– Transmit Data
+ Receive Data
+ Transmit Data
Signal Ground
Description
• Gateway inputs for 12 or 24 VDC power.
• Draws 250mA max.
• If the Access Control Panel (ACP) reader
power outputs do not source enough current
for the Gateway, use the ACP main regulated
12 VDC power supply or a separate UL294
Listed 12 or 24 VDC power-limited power
supply.
• Power input is non polarized.
• 4-Wire or 2-Wire bi-directional RS485
communication port for interface to Access
Control Panels.
• 2-Wire installation: Both 2|4 wire jumpers
should be added.
• 4 -Wire installation: Both 2|4 wire jumpers
should be removed.
• Refer to following pages for typical wiring
diagrams.
9