Mounting Options; Important - Schlage GWE Manual De Instrucciones

Mounting Options

1
Remove mounting plate from
Gateway.
Slide mounting plate down to remove.
2
Choose mounting option.
There are four different mounting options.
4
2
4
Desk mounting: Does not require screws.
1
Replace mounting plate, and place on flat
surface, mounting plate down.
Wall mounting: Place the mounting plate
2
against the wall in the desired location and
mark the indicated holes with a pencil.
Single gangbox mounting: Place the
3
mounting plate with the holes aligned with
the screw holes in the gangbox.
Double gangbox mounting: Place the
4
mounting plate with the holes aligned with
the screw holes in the gangbox.
3 4
3 4
3
Route wires.
Route wires through top hole in mounting plate.
Leave some slack when routing wires through
mounting plate to avoid damaging wires.
4
Secure mounting plate.
Use #6 screws to secure mounting plate to wall or
gangbox. Use the holes indicated on step 2.
5
Install wire cover.
2
Align the notches on the wire cover to the
Gateway, then slide straight in. Do not pinch
wires!

IMPORTANT

Wire hole
5