Mounting Options; Important - Allegion ENGAGE GWE Guia Del Usuario

2. Toggle the inside thumbturn 5 times
3. Confirm amber LED, indicating success.
The lock will remain available to connect for
30 seconds and then will resume attempts to
reconnect with the Gateway.

Mounting Options

1
Remove mounting plate from
Gateway.
Slide the mounting plate down to remove.
2
Choose mounting option.
There are four different mounting options.
4
2
4
Desk mounting: Does not require screws.
1
Replace mounting plate, and place on flat
surface, mounting plate down.
Wall mounting: Place the mounting plate
2
against the wall in the desired location and
mark the indicated holes with a pencil.
3 4
3 4
Single plastic gangbox mounting: Place
3
the mounting plate with the holes aligned
with the screw holes in the plastic gangbox.
Double plastic gangbox mounting: Place
4
the mounting plate with the holes aligned
with the screw holes in the plastic gangbox.
3
Route wires.
Route wires through top hole in mounting plate.
Leave some slack when routing wires through
mounting plate to avoid damaging wires.
4
Secure mounting plate.
Use #6 screws to secure mounting plate to wall or
gangbox. Use the holes indicated on step 2.
5
Install wire cover.
2
Align the notches on the wire cover to the
Gateway, then slide straight in. Do not pinch
wires!

IMPORTANT

Wire hole
7