Preparing The Devices For Use; Sr 300 Iem G2 Transmitter/Sr 350 Iem G2 Twin Transmitter - Sennheiser SR 300 IEM G2 Manual De Instrucciones

Preparing the devices for use

SR 300 IEM G2 transmitter/
SR 350 IEM G2 twin transmitter
Fitting the device feet
To ensure that the transmitter cannot slip on the surface on which it is placed,
four self-adhesive soft rubber feet are supplied.
Note:
Do not fit the rubber feet when rack mounting the transmitter.
CAUTION! Risk of staining of furniture surfaces!
Some furniture surfaces have been treated with varnish, polish
or synthetics which might cause stains when they come into
contact with other synthetics. Despite a thorough testing of the
synthetics used by us, we cannot rule out the possibility of
staining.
Do not place the transmitter on delicate surfaces.
Ensure that the base of the transmitter is clean and free from grease
before mounting the rubber feet.
Fix the rubber feet to the base of the transmitter by peeling off the safety
paper and fitting them as shown in the digram on the left.
Rack mounting
CAUTION! Risks when rack mounting the transmitter!
When installing the device in a closed or multi-rack assembly,
please consider
temperature within the rack may significantly rise above room
temperature.
The ambient temperature within the rack must not exceed
the temperature limit specified in the specifications.
When installing the device in a rack, take good care not to
affect the ventilation required for safe operation or provide
additional ventilation.
Make sure the mechanical loading of the rack is even to
avoid a hazardous condition such as a severely unbalanced
rack.
When connecting the device to the power supply, observe
the information indicated on the type plate. Avoid circuit
overloading. If necessary, provide overcurrent protection.
Ensure a reliable mains ground connection of the device by
taking appropriate measures.
When installing the device in a closed or multi-rack
assembly, please note that intrinsically harmless leakage
currents of the individual devices may accumulate, thereby
exceeding the allowable limit value. As a remedy, ground the
rack via an additional ground connection.
that, during operation, the ambient
11