Changing The Transmission Power (Sr 350 Iem G2 Only) - Sennheiser SR 300 IEM G2 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connect the two BNC connectors
transmitter.
Slide the twin transmitter into the 19'' rack.
Resecure the rack mount "ears"
Connect the telescopic antennas
Pull the end caps to extend the telescopic antennas

Changing the transmission power (SR 350 IEM G2 only)

With the SR 350 IEM G2 twin transmitter, you can choose between two
different transmission powers.
ATTENTION!
Danger of interference with other transmitters!
Depending on the selected transmission power and frequency,
you may have to apply for an approval from the respective
authority for a radio transmission licence, as you could interfere
with other transmitters. This approval will only be valid for the
approved transmission power. For detailed information, please
refer to the enclosed frequency data sheets and to the country-
specific frequency and transmission power overviews.
Apply for an approval, should country-specific regulations
on frequency and/or transmission power usage require this.
ATTENTION!
Danger of damage to the device!
Due to the high transmission power (100 mW) in the switch
position "STANDARD", the optional AC 2 transmitter combiner
must not be used as this can cause damage to the devices.
Use only the optional AC 3200 transmitter combiner (see
"Accessories and spare parts" on page 40).
Set the transmission power switch (RF POWER)
Transmission power will change as follows:
Switch position
LOW
STANDARD
to the BNC sockets
to the rack
.
to the BNC sockets
to the desired position.
Transmission power
15 mW
100 mW
on the twin
.
.
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sr 350 iem g2Ek 300 iem g2

Tabla de contenido