Using The Components; Switching The Components On/Off - Sennheiser SR 300 IEM G2 Manual De Instrucciones

18
Connecting the headphones
CAUTION! Danger of hearing damage!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
Set the volume for the connected headphones to the
minimum before putting the headphones on.
For monitoring purposes, connect the supplied earphones or any
Sennheiser stereo headphones with 3.5 mm stereo jack plug to the
headphone output (PHONES)
First, set the volume control
left as far as possible. Then gradually turn up the volume.

Using the components

Switching the components on/off

Switching the transmitter on/off
Press the ON button
To switch the transmitter off, press the
the display.
Note:
The transmitter can only be switched off when the standard display is
shown on the display panel. Within the operating menu, the
serves as the ESC (cancel) key, i.e. you cancel your entry and return to the
standard display.
After switch-off, the transmitter is in standby mode. To disconnect the
transmitter from the mains, pull out the mains connector from the wall
socket!
Switching the receiver on/off
To switch the receiver on, turn the volume control
clicks. The red LED lights up.
To switch the receiver off, turn the volume control
until it clicks. The red LED
Note:
The receiver has a short switch-on delay.
Remove the batteries or the accupack when the receiver will not be used
for extended periods of time.
.
to the lowest volume by turning it to the
to switch the transmitter on.
ON button until "OFF" appears on
goes off.
ON button
clockwise until it
counterclockwise