Entering Names; Loading The Factory-Preset Default Settings; Activating/Deactivating The Pilot Tone Evaluation (Receiver Only); Adjusting The Contrast Of The Graphic Display (Transmitter Only) - Sennheiser SR 300 IEM G2 Manual De Instrucciones

NAME
Name
RESET
Reset
PILOT
Pilot
LCD-Contr
32

Entering names

Via the "Name" menu, you can enter a freely selectable name for the
transmitter and the receiver. You can, for example, enter the name of the
performer for whom the adjustments have been made.
The name can be displayed on the standard display and can consist of up to
ten characters (transmitter) and up to six characters (receiver) such as:
letters (without pronounciation marks),
numbers from 0 to 9,
special characters e.g. () - . _ and spaces.
To enter a name, proceed as follows:
Press the SET button to get into the setting mode of the "Name" menu.
The first segment starts flashing on the display.
With the / rocker button you can now select a character. By briefly
pressing a button, the display jumps either forwards or backwards to the
next character. If you hold down a button, the display starts cycling
continuously.
Press the SET button to change to the next segment and select the next
character.
Have you entered the name completely? Press the
your setting and to return to the previous menu level.

Loading the factory-preset default settings

Via the "Reset" menu, you can load the factory-preset default settings. With
the receiver, however, the selected setting for the pilot tone remains
unchanged. After the reset, the device is restarted and the standard display
is shown on the display panel.
Activating/deactivating the pilot tone evaluation
(receiver only)
Via the "Pilot" menu, you can activate or deactivate the pilot tone evaluation
of the receiver.
The pilot tone is used to
code the transmitter's stereo signal,
support the squelch function (Squelch).
During stereo operation, the transmitter adds the pilot tone to the
transmitted stereo signal and the receiver detects and evaluates the pilot
tone. When the transmitter is set to mono operation, deactivate the pilot
tone evaluation on the receiver.
You can combine units of first and second generation ew 300 IEM systems
without any problems.
Adjusting the contrast of the graphic display (transmitter
only)
Via the "LCD Contr" menu, you can adjust the contrast of the graphic display
in 16 steps.
SET button to store