Setup; Pipe Adapter - Textron GREENLEE Ultra Tugger 6800-22 Manual De Operación

Setup

Pipe Adapter

Requires: Exposed metallic pull conduit
of least 63 mm (2-1/2") diameter.
Do not mount the pipe adapter to the
following:
• steel conduit less than 65 mm
(2-1/2") in diameter
• PVC conduit of any size
These conduits will not support the
loads imposed by the puller.
Failure to observe this warning can
result in severe injury or death.
NO
When setting up the pipe adapter, do
not use the vise chains on a structural
support that is less than 51 mm (2")
or more than 254 mm (10") wide. An
oversized or undersized structural
NO
support can allow the puller to slide
or break loose and strike operator.
Failure to observe this warning can
result in severe injury or death.
Greenlee / A Textron Company
6800-22 Ultra Tugger
29
Cable Puller and Pulling Package
®
1. Remove the sheave from the frame.
Sheave
Sheave Shaft
2. Position the frame against the conduit.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Hitch Pin Clip
Frame