Wheeled Carriage - Textron GREENLEE Ultra Tugger 6800-22 Manual De Operación

Setup (cont'd)

Wheeled Carriage

Requires: Adequate clearance.
See "Typical Setups Illustrated."
1. Mount the boom mount to the wheeled carriage.
Align the boom mount holes with the top holes in
the wheeled carriage, as illustrated. Install a pin
through the boom mount and wheeled carriage.
Secure the pin with a hitch pin clip.
2. Position the puller's gearbox above the boom
mount cradle. Align the puller so that the puller
mounting plates straddle the boom mount plates.
Lower the puller onto the boom mount. Install two
pins from the motor side. Secure the pins with two
hitch pin clips.
Greenlee / A Textron Company
6800-22 Ultra Tugger
33
Cable Puller and Pulling Package
®
3. Check the right angle sheave support tube to be
sure it is fastened with the pin.
4. Rotate the puller and boom mount as shown. When
the second hole in the boom mount is aligned with
the second hole in the wheeled carriage, install a
pin. Secure the pin with a hitch pin clip.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Removable Pin