Booms With Elbow Unit And Nose Unit - Textron GREENLEE Ultra Tugger 6800-22 Manual De Operación

Setup (cont'd)
Mounting Components (cont'd)

Booms with Elbow Unit and Nose Unit

• Use only straight 3" diameter rigid steel conduit or
Schedule 40 steel pipe for the boom tubes.
• Do not use boom tubes longer than 3 meters (10').
Longer booms may bend or break.
Failure to observe this warning can result in severe
injury or death.
Set up the elbow unit as shown.
Improper setup will cause the elbow
STRAIGHT EDGE
unit to collapse.
Failure to observe this warning can
result in severe injury or death.
Greenlee / A Textron Company
6800-22 Ultra Tugger
3 m (10')
MAXIMUM
Sight Hole
Sight Hole
Cable Puller and Pulling Package
®
Use these boom tubes only:
• boom tubes supplied with the Ultra Tugger
• 3" rigid steel conduit (3 m or 10' maximum)
• 3" Schedule 40 pipe (3 m or 10' maximum)
1. Slide the boom tube into the boom mount until the
tube bottoms out. Sight the tube through the sight
hole to be sure the tube is fully inserted. Tighten the
set screw.
2. Slide the elbow unit onto the tube until the tube
bottoms out. Sight the tube through the sight hole
to be sure the tube is fully inserted. Tighten the set
screw.
3. Adjust the elbow to an appropriate angle and lock
it in place with a pin. Secure the pin with a hitch pin
clip.
4. Slide the boom tube into the elbow unit until the
tube bottoms out. Sight the tube through the sight
hole to be sure the tube is fully inserted. Tighten the
set screw.
5. Slide the nose unit onto the tube until the tube
bottoms out. Sight the tube through the sight hole
to be sure the tube is fully inserted. Tighten the set
screw.
35
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Sight Hole