WEG CFW500 ENC Guia De Instalacion página 11

The Figure 3 on page 11
signals of encoder to spin clockwise rotating direction.
Signal
A
A
B
B
Figure 3: Standard phase of encoder signals
The location of the DIP switches to select the kind of
analog output and input signal can be better viewed in
Figure A.2 on page 30
To use the analog inputs and/ or outputs with current
signal, switch S1 and related parameters must be set
as indicated in
termination resistors of the RS-485 interface, see
4 on page 12. To set the power supply output for the
encoder + VE, see
For further details about the control connections see
chapter 3 Installation and Connection of the inverter.
NOTE!
The digital input signal DI5 is allways NPN
input instead of P0271 configuration.
ENC Encoder Input Plug-in Module
shows the phase sequence
and
Table 3 on page
Table 5 on page
Figure A.3 on page
12. To activate the
12.
CFW500 | 11
Time
31.
Table