Step 6 Preparing The Dishwasher - Samsung DW80H995 Serie Manual De Instalación

Ocultar thumbs Ver también para DW80H995 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Plumbing
t.
Check the hot water
connection
on the front left-side of the base of the dishwasher.
The mounting
plate should
be secured
to the front of the base, the threads
inside the
connection
should
be smooth
and shiny, and the area should
be clean and free of any
debris.
2.
Make sure the dish washer
and the accessories
are all included
in the package
to ensure
these assemblies
are not cracked
and that all connections
are secure.
3.
Check the drain hose for any holes or deformities
that could allow a water leak during
draining.
Electrical
t.
2.
Appearance
t.
2.
3.
Confirm the junction
box cover is secured to the junction
box on the front right-side
of the
base of the dishwasher.
Confirm the electrical
box was not damaged
during shipping
and that it is secured
to the
base of the dishwasher.
Confirm there are no dents or scratches
on the front of the dishwasher.
Check the edges of the doors for any roughness
or cracking
Check the control
panel to ensure it is clear and unscratched,
and that all the control markers
are in their proper places.
Confirm you have all the parts listed in Step 1 on page 6.
STEP 6
PREPARING
THE DISHWASHER
t.
Ensure that the circuit breaker
and water
supply valve are turned off before proceeding
with
the following
steps.
/_
Before you move or lay down the dishwasher
for installation,
make sure to adjust the height
oAu"-_--_T,o
of the legs so the legs are as short as possible.
This prevents the legs from breaking.
Level the dishwasher
by adjusting
the height of the legs after you have the dishwasher
in
place.
2.
Wrap Teflon tape on both sides of the 90 ° elbow. Then, insert the elbow into the inlet
valve (see Figure 4-B). Tighten until the elbow
is tight and pointing towards
the water
hose
channel
in the base of the dishwasher
(about 4 o'clock). To prevent the inlet valve from being
blocked,
make sure that the Teflon tape does not enter the valve. Do not over tighten.
3.
Cut the strings securing
the drain hose to the back of the dishwasher.
Roll-out the hose.
Make sure there are no kinks and that the hose is not bent at any extreme
angles that could
constrict
the flow of water.
4.
Remove the junction
box cover located
at the bottom
front right of the dishwasher
using a
screwdriver,
and then Install the strain relief (Figure 4 - C). Make sure to keep the junction
box
cover you removed.
It is used in Step 10, Wiring Connections.
5.
If the countertop
is made of wood
or a material that is not damaged
by drilling, attach the
two (2) Installation
brackets
that were supplied
with the dishwasher
using the supplied
screws
(Figure 4 - A). They will be used in Step 8, Securing
the Dishwasher.
6.
Use the provided
clamp to connect
the provided
drain hose to the outlet at the back of the
product.
If the product
has the drain outlet in the right side, use the provided
holder hose to
facilitate the connection.
12 installing the dishwasher
D1,*Tg0H9950US
00151A
06 EN
150216illdd
Sec3:12

Publicidad

Tabla de contenido
loading

Tabla de contenido