Installation
3,
If the washer is level, the pulsator (A) is
positioned
at the center of the water as
shown in the figure.
If not, level your washer by turning
the front leveling feet clockwise or
counterclockwise
as necessary.
NOTE
Turn the front leveling feet clockwise
(B) to
lower the washer, and counterclockwise
(C)
to raise the washer.
STEP 5
Powering
your washer
Plug the power cord into a 3-prong,
well grounded
!20 volt 60 Hz approved
electrical
outlet protected
by a !5-amp
fuse
or comparable circuit breaker.
Your washer is grounded through
the third
prong of the power cord when plugged into
a three-prong
grounded electrical
outlet.
Test run
Make sure that you install your washer
correctly
by running the Rinse+Spin after
the installation
is complete.
26
English
WAS000J WA8700J
"_\TA52J03133Y 01 EN indd 26
2015/4/20
15:33:46