Safety Instructions For Hammer Drills; Original Accessories/Auxiliary Equipment; Before Use; Charging The Battery Pack (See Fig. A) - Parkside PABH 20-Li B2 Traducción Del Manual De Instrucciones Original

Safety instructions for hammer drills

■ Wear hearing protection. Exposure
to loud noise can lead to hearing loss.
■ Use the additional handles supplied with the
appliance. Loss of control can lead to injuries.
■ Hold the appliance using the insulated handle
areas if you are carry out any work during
which the attached tool could contact hidden
power cables. Contact with a live wire may
electrify exposed metal parts of the power tool
and could give the operator an electric shock.
■ Wear a dust mask.
WARNING! TOXIC DUST!
► Working with the tool can produce harmful/
toxic dusts which represent a health hazard
for the person operating the appliance and
for anyone else in the vicinity.
■ CAUTION, POWER CABLES! DANGER!
Ensure that you are not likely to hit power, gas
or water supply lines when you are working
with the power tool. If necessary, check with a
service line detector before you start to cut or
drill into a surface.
│ GB │ IE
■ 20
Original accessories/auxiliary
equipment
■ Only use the accessories and additional
equipment that are specified in the operating
instructions and compatible with the appli-
ance.

Before use

Charging the battery pack (see fig. A)
CAUTION!
► Always pull out the plug before you remove
the battery pack
battery pack to the charger.
► Never charge the battery pack
the ambient temperature is below 10°C or
above 40°C.
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket. The con-
trol LED lights up red.
♦ The green LED indicates that the charging
process is complete and the battery pack
ready.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram). The status/remaining charge will be
shown on the battery display LED
♦ RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
from or connect the
when
to the high-speed
(see Fig. A).
to
as follows:
PABH 20-Li B2
is