System Diagram; Receiver - Leviton 41910-U2B Guia Del Usuario

INTRODUCTION

System Diagram

Transmitter [TX]
(Front View)

Receiver

The Receiver provides two USB Type A ports for connecting standard USB devices allowing up to 1 Amp of power per USB
port, or 1.5 Amps total when both ports are used concurrently for device operation and charging. Additional devices may
be connected by attaching USB hubs to the Receiver. The Receiver is normally powered using the included power supply.
However, if AC power is not available at the receiver location, it can be powered from the Transmitter over the Category cable
link. Please see the Transmitter section for further detail.
Item Type Description
1 USB Device Ports Accepts USB device(s) using Type A connectors.
2 Power LED (Blue) LED turns ON when power is supplied.
3 Link LED (Green) Indicates a valid USB link is established between the Transmitter and Receiver.
LED turns ON when link between Transmitter and Receiver is established.
LED is OFF when there is no link between the Transmitter and Receiver.
LED is slow blinking when the unit is attempting to establish a link.
4 Host LED (Green) Indicates that the extender system is properly enumerated on the host computer. LED blinks
when the extender system is in a suspended state.
5 Activity LED (Amber) Indicates data transmission is occurring between the Transmitter and Receiver.
LED blinks intermittently with or without a USB device connected.
When the Transmitter and Receivers are in suspend mode, the LED is OFF.
6 Power Port Connects to the power supply.
7 Link Port (RJ45) Accepts Category cable link RJ45 connector.
8 Configuration Port Reserved for manufacturer use.
9 Mode Reserved for manufacturer use.
Category
Cabling
AC Power Power
Source Adapter
Front View
Rear View
4
Receiver [RX]
(Front View)
1 2 3 4 5
6 7 8 9
24 1A Link Config Mode