Polaris 360 Manual Del Proprietário página 7

Assemble Cleaner
1. Remove the pressure tester from the hose by unscrewing the hose nut and
pulling off hose.
2. Use hose nut from the pressure tester to secure hose to the cleaner body at the
feed pipe.
3. The filter bag is packaged in the collar area on the cleaner body. Pull out the
bag and snap the bag tie collar onto the feed hose.
4. Push Head Float all the way in, against cleaner body.
5. Place the Polaris into the pool. Turn on the pool filtration pump.
Check for Proper Wheel RPM
4
Before operating the Polaris, check for proper wheel revolutions per minute (RPM). For maximum efficiency, the Polaris
should operate between 28 and 32 RPM.
1. Mark the single-wheel side tire.
2. Turn pump on, hold cleaner below water level and count wheel revolutions for 1 minute.
3. Optimum speed should be between 28 and 32 RPM.
If count is less than 28 RPM:
• Check the filter screen in the Quick Disconnect for debris.
• Clean the skimmer, filter and pump basket.
• Check the hoses, connections and swivels for leaks.
• If the cleaner is connected to a dedicated return line, adjust the 3-way diverter to increase water flow.
If count is more than 32 RPM, unscrew the Pressure Relief Valve until the proper RPM is reached. If an adjustable valve has
been installed, adjust the valve to reduce the amount of water flow.
Single-wheel Side
Sweep Hose
www.polarispool.com
Feed
Pipe
Hose Nut