Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Mod. H871.
Connect the two terminals (107 and
108)
Fig.6,
coming
handlebar stem (12) and the main
body (40).
Insert the handlebar stem (12) onto
the boss on the main body (40) taking
care not to pinch the cables.
Fit the bolts (13) and flat washers, as
shown in Fig.6, align the handlebar
stem and hand tighten.
Mod. H872N.
Connect the two terminals (107) and
(108)
Fig.7,
handlebar stem (12) and the main
body (40).
Connect the two terminals (136) and
(137), coming out of the handlebar
stem (12) and the main body (40), as
shown in Fig.7.
Insert the handlebar stem (12) onto
the boss on the main body (40) taking
care not to pinch the cables.
Fit the bolts (13) and flat washers, as
shown in Fig.7, align the handlebar
stem and hand tighten.
5. FITTING THE BOTTLE HOLDER.-
Take the bottle holder (18), insert it in
through the top of the handlebar (12),
Fig.8.
Next, release the screws (109) and
(17) on the handlebar (12), position
the bottle holder and secure it by
using the screws (109) and (17)
removed previously.
6. INSTRUCTIONS FOR FITTING
THE SADDLE.-
In order to raise or lower the saddle
post (39), Fig.9, first loosen off the
control knob (41) on the saddle post a
little by turning it in an anticlockwise
direction.
out
of
coming
out
of
Pull the control knob back and without
releasing it, move the saddle post up or
the
down. Next, take the horizontal tube for
the saddle (34) and attach the saddle
(33) to it, Fig.9, tighten the nuts (Z).
VERTICAL ADJUSTMENT.
In order to raise or lower the saddle
post, first loosen off the control knob
(41) on the saddle post a little by
turning it in an anticlockwise direction,
pull the control knob back and without
releasing it, move the saddle post up
or down, Fig.9. When it is at the right
the
height release the knob and it will lock
into a hole on the saddle post. Tighten
it up by turning the control knob (41) in
a clockwise direction.
HORIZONTAL ADJUSTMENT.
To adjust the saddle's horizontal
position, loosen the control knob (37)
on the saddle's horizontal bar and
move the saddle, along with the bar,
into the desired position, then tighten
the control knob securely, Fig.9.
TILTING THE SADDLE.
The saddle can be tilted backward or
forward. Loosen off nut (Z) shown in
Fig.9, located under the saddle, tilt the
saddle into the desired position and
then retighten the nut securely.
Do not adjust the tilt of the saddle
while you are still sitting on it.
16
Publicidad
Tabla de contenido
