Installation In Harness Mode - Britax Child Safety GROW WITH YOU Guia Del Usuario

Britax Child Safety, Inc.

Installation in Harness Mode

Harness Mode: Lap-Shoulder Belt
Before you begin:
• Check that your vehicle has a top tether anchor.
• Britax recommends that the top tether be used at all
times when installing the child seat. Using the top
tether will improve the stability of your child seat and
reduce the risk of injury. Check your vehicle owner's
manual for tether anchor locations.
• Loosen the tether and place it over the child seat
back to keep it from becoming pinned between the
child seat and vehicle seat during installation.
• Adjust the child seat to desired position and place
forward facing on the vehicle seat.
1. Pull seat cover forward.
2. Pull the vehicle belt out
and route along the green
belt path. Verify that the
belt is not twisted and
then buckle.
3. Push the child seat firmly
into the vehicle seat while
removing all slack from
the lap part (A) and the
shoulder part (B) of the
vehicle belt.
NOTE: Ensure that the
vehicle belt is locked as directed by your vehicle owner's
manual.
NOTE: The child seat is secure when it cannot be moved
front-to-back or side-to-side more than 1 in (2.5 cm) at the
belt path. If the child seat is not secure, repeat the installation
procedure or use a different seating location.
10