Standard Setup/ Cable Connections; Midi - Hughes & Kettner Full House TubeMeister 36 Manual Del Usuario

14
SPEAKER
Connect a speaker cabinet designed for
guitar amps to this jack. Using a single speaker cord,
you can connect any cabinet or combination of
cabinets whose total impedance ranges between 8 Ω
and 16 Ω. The formula below serves to calculate the
overall impedance (R) of two cabinets with different
impedances (R1 and R2)
For cabinets wired in series: R = R1 + R2
Example: If you connect two 8-Ω cabinets, the
overall impedance is 16 Ω. However, very few
modern cabinets are wired in series. Parallel circuits
are far more common.
For cabinets wired in parallel:
R = (R1 x R2) / (R1 + R2)
Here is an example with two 16-Ω cabs:
R = (16 x 16) / (16 + 16)
R = 256 / 32
R = 8
HEADS UP: On the Combo version, this jack is
already occupied by the internal speaker. Feel free to
disconnect this speaker from the SPEAKER OUT jack
and connect another cabinet designed for guitar amps.
MAINS IN
Connect the factory-included power cord (MAINS
LEAD) to this socket. The shaft holding the mains
fuses is located next to this socket. Replacing blown
fuses is a job to be carried out by fully qualified
technicians only using exclusively the specified
replacement fuses (see Technical Specifications).
2

Standard Setup/ Cable Connections

Stage or Recording Mixer
RED BOX
DI OUT
3

MIDI

TubeMeister 36 is equipped with a 7-pin MIDI port.
Two of the pins serve as a phantom power supply,
providing 20 volts of direct current to power a device
such as the Hughes & Kettner FSM 432 without
requiring an additional wall-wart. A standard 5-pin
connector does not tap this phantom power feed, so
you can use a cable equipped with this type of plug
to connect any standard MIDI board.
With TubeMeister 36's MIDI facility, command
and control is an exercise in convenience with lots of
intriguing switching and storage possibilities. Given
a MIDI-enabled controller, foot board or multi-
effector and a fistful of MIDI presets (see below),
you can dip into the TubeMeister 36's deep sonic
well and pull up any conceivable combination of the
following functions at the tap of a toe:
One of the 3 channels CLEAN, LEAD, CRUNCH
+ FX-LOOP on/off
+ REVERB on/off
+ The full 36W or one of the POWER SOAK stages
18W, 5W, 1W or Speaker Off
FX-Unit
Return
Send
MIDI
FX/Reverb
Channels