Preparation - Alpine NVE-N872A Guía De Instalación Y Conexiones

1. Preparation

1
Check accessory parts.
GPS antenna (5 m) Antenna mounting plate
Remote control Remote control holder
double-faced tape
(for voice recognition
(for voice recognition
Speak button )
1 Bracket 2 Floor base
One each for left
and right
6 Spring washer 7 Flanged hex nut
(M6) (M6)
× 4
2
Prepare tools and mounting information.
Screwdriver Electrical tape
Multimeter
Spanner
3
Park the vehicle in a safe and level location.
Note:
Before working on the installation check and verify that
your vehicle lights are working correctly and your
vehicle status indicators e.g. Engine needs service, etc.
are not on. If these indicators are on, please resolve the
problem before installing the Navigation System.
Cable clamp
(for GPS antenna)
Battery (AAA)
× 4
Cable clamp
Speak button )
3 Screw with double
washer (M4 × 8)
× 2
8 Wing nut (M6)
× 4 × 4
Pliers
Pencil and eraser
× 5
Parking brake aux. cord
× 2
Microphone for voice
recognition (3.5 m)
(2.5 m) (4.5 m)
Power cables
4 Hex bolt (M6 × 50)
× 4
9 Velcro fastener ! Velcro tape
× 2
4
Apply the brake and remove the ignition key.
5
Mount the antenna on the roof.
Clean dust and oil at the mounting location and
mount the antenna.
Notes:
• The magnet of the antenna is very strong. Proceed
cautiously to prevent any damage to the vehicle's body.
Keep the magnet away from articles susceptible to
magnetic fields such as credit cards, watches, etc.
• Do not paint the antenna. Reception sensitivity may be
decreased.
× 2
Solderless connector
Speak button for voice
recognition (7 m)
13P RGB extension
cable (6 m)
5 Flanged self-tapping
screw (M5 × 15)
× 4 × 4
" Self-tapping
screw (M3 × 12)
Antenna
× 4
5