Alpine NVE-N872A Guía De Instalación Y Conexiones página 9

3
Connect the power lead to this unit.
Insert until a click sound is heard.
4
Wrap electrical tape around end of leads not
used.
5
Connect the battery (–) terminal and turn the
ignition key to the ACC or ON position. Check
to see if operation can be performed properly.
(Is the power turned on? Is the illumination
turned on?)
You can check the language selection menu with
the monitor. (Refer to the Owner's Manual for
details.) Go to step 6 after checking is completed.
Note:
Before connecting the battery terminal, check the battery
voltage using the multimeter and make sure that it
registers at least 12V.
6
Turn the ignition key to the OFF position to
turn off the power after completion of the
check.
8
ON
OFF
7
Pull out the ignition key and remove the
battery terminal (–) again to begin installation
procedure.