Error Messages; Messaggi Di Errore; Mensajes De Error; Mensagens De Erro - Epson SX440W Manual De Funcionamiento Básico

Tabla de contenido

Publicidad

Error Messages

Messaggi di errore

Mensajes de error

Mensagens de erro

& 50
R
EN
& 51
R
IT
& 52
R
ES
& 53
R
PT
0
EN
Error Messages
Paper jam.
Paper out. Load paper.
Communication error. Connect computer.
Printer error. Turn power off and on again.
A printer's ink pad is nearing the end of its service life.
Please contact Epson Support.
A printer's ink pad is at the end of its service life. Please
contact Epson Support.
Operation canceled. No memory card recognized.
Combination of IP address and subnet mask is invalid. See
documentation.
Recovery Mode
Solution
& 58, 59
R
Load some paper. Otherwise, make sure the number of sheets does not
exceed the limit specified for the type of media you are using.
Make sure the computer is connected correctly. If the error message
still appears, make sure that scanning software is installed on your
computer and that the software settings are correct.
Turn the printer off and then back on. Make sure that no paper is still in
the printer. If the error message still appears, contact Epson support.
Press x to resume printing. The message will be displayed until the ink
pad is replaced. Contact Epson support to replace ink pads before the
end of their service life. When the ink pads are saturated, the printer
stops and Epson support is required to continue printing.
Contact Epson support to replace ink pads.
Make sure the memory card has been inserted correctly. If it is inserted
correctly, check to see if there is a problem with the card and try again.
See the online Network Guide.
The firmware update has failed. You will need to re-attempt the
firmware update. Ready a USB cable and visit your local Epson website
for further instructions.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sx445wNx430

Tabla de contenido