English
tachment elements into the frame at-
tachment points at the same time.
· Check that the chair has been attached
properly by trying to lift it from the
frame. NB! The frame cannot be folded
with the seat facing backwards!
Remove the seat (q)
· Slide the unlocking buttons upwards
until you hear a click on both sides. Be
careful! The seat is now unlocked; the
red section on the frame attachment
points are now visible. The seat can
vertically be removed from the attach-
ment points.
adjust the back support (r)
· Pull the button at the back of the seat
upwards and hold it upwards.
· The back support has 4 positions.
Place the back support in the desired
position and release the button to lock
the position.
attach and remove bumper bar (s1)
· To secure the front bumper, press the
ends of the bumper into the recesses
intended for this purpose on the seat
until you hear a click.
· Press the unlock buttons on both sides
of the front of the bumper bar to re-
move the bumper bar from the chair.
adjust the leg support (s2)
· Lift the leg support to place it upwards.
· Push the buttons on both sides of the
leg support and push the leg support
downwards to lower it.
Fully reclined position (t)
· The seat has a fully reclined position to
make the seat suitable for children from
birth ! The use of a suitable pram body
is always recommended and preferred
for children from birth up to the age that
8
your child can sit up unassisted.
· To put the seat in the fully reclined po-
sition, put the leg rest in its highest po-
sition (t1) and the backrest of the seat
in its most reclined position (t2).
· Release the two press studs on each
side of the seat (t3). Open the zip-
per around the leg support (t4). There
is a fabric side support in the pocket
behind the leg support, which you can
pull out. Now you can put the side sup-
port up and attach the two press studs
on each side onto the plastic shell of
the seat (t5). The press studs of the
seat cover can now be attached to the
press studs of the side support.
· ! The hood of the seat needs to be in
the first upright position (not extend-
ed). There are 2 straps on either side
of the seat to keep the canopy in this
position. Make sure the two straps on
either side of the seat are attached to
the press studs on the canopy (t6).
Folding the frame with the seat facing
forwards (u)
· Stand behind the chassis and put the
chassis on the brake. Fold the hood
back if it is folded out. Fold the seat
unit in two by tilting the back support
forwards (s1).
· Push the height adjustment button (s2)
of the pushbar in and move this to the
lowest setting. Pull the folding safe-
guard (s3) towards you on both sides
and turn the pushbar forwards until the
pushbar lies on the frame (s4).
· Pinch the chassis unlocking buttons
and fold the chassis (s5).
· The folding safeguard locks automati-
cally when the product is folded up.
· The integrated carry handle, which is
located under the rear axle, has
made lifting and carrying the folded
pushchair more practical.