The Seat P; The Maxi-Cosi Car Seat; Place The Maxi-Cosi Adapters On The Frame (Y) - Mutsy igo Serie Manual De Instrucciones

· NB! The chassis cannot be folded with
the seat facing backwards!
Unfolding the frame with the seat
· Press the folding safeguard inwards
(a1) and tilt the upper frame until the
lower support clicks into place (a2) and
move the push-bar backwards until you
hear a second click (b).
· After unfolding the seat, always push
the bumper bar to its upright posi-
tion before placing a child in the seat.
Make sure that no child is near the
bumper bar when moving it.
· Before use always check that the pram
has been unfolded and secured correctly.
The hood (v1, v2)
· Hold the front hood bar in the centre
and move it forwards or rearwards to
adjust the hood (v1)
· Open the zipper at the back of the
opened hood in order to enlarge it. Close
the zipper to again reduce the hood (v2)
· Pull the flap on the front side of the
hood outwards to additionally enlarge
the hood. Push the flap inwards to
again reduce the hood.
assemble the rain cover on the pushchair (w)
· Make sure that the hood of the seat is
in the upright position.
· Open the zipper in the rain cover in or-
der to attach it to the enlarged hood of
the seat.
· Place the rain cover from top to bottom
over the pushchair and make sure that
the rain cover is attached well behind the
back support and over the leg support.
The 5-point safety harness (x1, x2)
· Place your child in the pushchair and
make sure that the legs of your child are
placed on each side of the leg piece.
· Make sure that the hip and shoulder
belt is positioned correctly over your
child and place both plastic clamps in
the central part of the harness attached
to the leg piece (x1).
· To adjust the length of the shoulder
straps, loosen the shoulder protectors
from the belt by undoing the velcro.
This will reveal the belt buckles. Adjust
the length by sliding the buckles along
both shoulder straps until your child is
comfortably secure.
press down the velcro on both sides to
relock the shoulder protectors in place.
· The back support contains three posi-
tions for the shoulder belts. To adjust
the position, open the panel behind
the back support (x2). Loosen the
shoulder belts by moving the attach-
ment rings through the openings.
Move the attachment rings through the
desired openings so that the shoulder
belts are positioned properly and click
the panel back.
· Regularly check the length and posi-
tion of the belts and adjust, where
necessary.
Maxi-Cosi car seat
· The Maxi-Cosi car seat adapters are
suitable for use with the Maxi Cosi
Mico: 5-22 lbs. 19-22 in. (2,2-10 kg,
48-74 cm) and Maxi Cosi Prezi: 4-30
lbs., <29 in. (1.8-13.6 kg, <74cm).
· Always observe the instructions in the
manual of your Maxi-Cosi car seat be-
fore you start using the car seat.
· Make sure that the frame has fully been
unfolded and the brake blocked during
all actions indicated below.
Place the Maxi-Cosi adapters on the
frame (y)
· The adapter marked with 'R' is placed
on the right side of the frame, the adapt-
er marked 'L' is placed on the left side.
English
After adjusting,
9