Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
[] Basic Connection
Thissection describes h owto connect t heunit toan antenna,cablereceiver orsatellitebox.
Note:
• Besure your antenna or other device is connected properly before plugging in the power cord.
[Antenna
Cable Connection]
When connecting
the unit to an antenna
or cable TV signal (without
receiver/satellite
box)
Connect
the RF coaxial cable on your home outlet to the antenna
input jack of this unit.
e.g.)
VHF/UHF_
antenna
_
rear of this unit
i::!
cableTV
signal
RF coaxial
cable
_Once connections
are completed,
turn on the unit and begin initial setup.
Channel
scanning
is necessary for the unit to memorize
all available
channels in your area.
(Refer to "Initial
Setup" on page 12.)
Note:
• If you have anyquestion about the DTV's antenna, visit www.antennaweb.org for further information.
• Foryour safety and to avoid damage to device, please unplug the RFcoaxial cable from the antenna input jack before moving the unit.
• If you use an antenna to receiveanalog TV,it should also work for DTV reception. Outdoor or attic antennas will be more effective than set-
top versions.
• To easilyswitch your reception source between antenna and cable, install an antenna selector.
• If you connect to the cable system directly, contact the CATVinstaller.
[Connection
to Cable Receiver or Satellite Box]
Use an RCA component
video cable to connect
the component
video input jack of the unit to the component
video
output
jack of the cable receiver / satellite box.
If you connect
to the unit's component
video input jack, connect
RCA audio cable to the audio L/R jack of VIDE02.
e.g.}
satellite
dish
RFcoaxial
cap l e
(green)
(blue)
(red)
F
AUDIOOUT_
_
COMPONENTVIDEOOUT
cable receiver/satellite
box
rear of this unit
RCA audio
cable
ii,i:i'_
iii_i'!:i
iiii!!
ii_i::ii
ii I L
You can also connect
this unit to the cable receiver or satellite box other than the component
video output
jack
because they might
have different
output
jacks.
Required
cables and connecting
methods
of the cable receiver / satellite
box, or the availability
channel
for the clear
QAM may differ depending
on the cable/satellite
provider.
For more information,
please contact
your cable/satellite
provider.
EN
Publicidad
Tabla de contenido
